Status of This Memo

This is an Internet Standards Track document.¶

This document is a product of the Internet Engineering Task Force (IETF). It represents the consensus of the IETF community. It has received public review and has been approved for publication by the Internet Engineering Steering Group (IESG). Further information on Internet Standards is available in Section 2 of RFC 7841.¶

Information about the current status of this document, any errata, and how to provide feedback on it may be obtained at https://www.rfc-editor.org/info/rfc8999.¶

Copyright Notice

Copyright (c) 2021 IETF Trust and the persons identified as the document authors. All rights reserved.¶

This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License.¶

Table of Contents

1. An Extremely Abstract Description of QUIC

QUIC is a connection-oriented protocol between two endpoints. Those endpoints exchange UDP datagrams. These UDP datagrams contain QUIC packets. QUIC endpoints use QUIC packets to establish a QUIC connection, which is shared protocol state between those endpoints.¶

2. Fixed Properties of All QUIC Versions

In addition to providing secure, multiplexed transport, QUIC [QUIC-TRANSPORT] allows for the option to negotiate a version. This allows the protocol to change over time in response to new requirements. Many characteristics of the protocol could change between versions.¶

This document describes the subset of QUIC that is intended to remain stable as new versions are developed and deployed. All of these invariants are independent of the IP version.¶

The primary goal of this document is to ensure that it is possible to deploy new versions of QUIC. By documenting the properties that cannot change, this document aims to preserve the ability for QUIC endpoints to negotiate changes to any other aspect of the protocol. As a consequence, this also guarantees a minimal amount of information that is made available to entities other than endpoints. Unless specifically prohibited in this document, any aspect of the protocol can change between different versions.¶

Appendix A contains a non-exhaustive list of some incorrect assumptions that might be made based on knowledge of QUIC version 1; these do not apply to every version of QUIC.¶

3. Conventions and Definitions

The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 [RFC2119] [RFC8174] when, and only when, they appear in all capitals, as shown here.¶

This document defines requirements on future QUIC versions, even where normative language is not used.¶

This document uses terms and notational conventions from [QUIC-TRANSPORT].¶

4. Notational Conventions

The format of packets is described using the notation defined in this section. This notation is the same as that used in [QUIC-TRANSPORT].¶

Complex fields are named and then followed by a list of fields surrounded by a pair of matching braces. Each field in this list is separated by commas.¶

Individual fields include length information, plus indications about fixed value, optionality, or repetitions. Individual fields use the following notational conventions, with all lengths in bits:¶

x (A):

Indicates that x is A bits long¶

x (A..B):

Indicates that x can be any length from A to B; A can be omitted to indicate a minimum of zero bits, and B can be omitted to indicate no set upper limit; values in this format always end on a byte boundary¶

x (L) = C:

Indicates that x has a fixed value of C; the length of x is described by L, which can use any of the length forms above¶

x (L) ...:

Indicates that x is repeated zero or more times and that each instance has a length of L¶

This document uses network byte order (that is, big endian) values. Fields are placed starting from the high-order bits of each byte.¶

Figure 1 shows an example structure:¶

Example Structure {
  One-bit Field (1),
  7-bit Field with Fixed Value (7) = 61,
  Arbitrary-Length Field (..),
  Variable-Length Field (8..24),
  Repeated Field (8) ...,
}

5. QUIC Packets

QUIC endpoints exchange UDP datagrams that contain one or more QUIC packets. This section describes the invariant characteristics of a QUIC packet. A version of QUIC could permit multiple QUIC packets in a single UDP datagram, but the invariant properties only describe the first packet in a datagram.¶

QUIC defines two types of packet headers: long and short. Packets with a long header are identified by the most significant bit of the first byte being set; packets with a short header have that bit cleared.¶

QUIC packets might be integrity protected, including the header. However, QUIC Version Negotiation packets are not integrity protected; see Section 6.¶

Aside from the values described here, the payload of QUIC packets is version specific and of arbitrary length.¶

Long Header Packet {
  Header Form (1) = 1,
  Version-Specific Bits (7),
  Version (32),
  Destination Connection ID Length (8),
  Destination Connection ID (0..2040),
  Source Connection ID Length (8),
  Source Connection ID (0..2040),
  Version-Specific Data (..),
}

Short Header Packet {
  Header Form (1) = 0,
  Version-Specific Bits (7),
  Destination Connection ID (..),
  Version-Specific Data (..),
}

6. Version Negotiation

A QUIC endpoint that receives a packet with a long header and a version it either does not understand or does not support might send a Version Negotiation packet in response. Packets with a short header do not trigger version negotiation.¶

A Version Negotiation packet sets the high bit of the first byte, and thus it conforms with the format of a packet with a long header as defined in Section 5.1. A Version Negotiation packet is identifiable as such by the Version field, which is set to 0x00000000.¶

Version Negotiation Packet {
  Header Form (1) = 1,
  Unused (7),
  Version (32) = 0,
  Destination Connection ID Length (8),
  Destination Connection ID (0..2040),
  Source Connection ID Length (8),
  Source Connection ID (0..2040),
  Supported Version (32) ...,
}

Only the most significant bit of the first byte of a Version Negotiation packet has any defined value. The remaining 7 bits, labeled "Unused", can be set to any value when sending and MUST be ignored on receipt.¶

After the Source Connection ID field, the Version Negotiation packet contains a list of Supported Version fields, each identifying a version that the endpoint sending the packet supports. A Version Negotiation packet contains no other fields. An endpoint MUST ignore a packet that contains no Supported Version fields or contains a truncated Supported Version value.¶

Version Negotiation packets do not use integrity or confidentiality protection. Specific QUIC versions might include protocol elements that allow endpoints to detect modification or corruption in the set of supported versions.¶

An endpoint MUST include the value from the Source Connection ID field of the packet it receives in the Destination Connection ID field. The value for the Source Connection ID field MUST be copied from the Destination Connection ID field of the received packet, which is initially randomly selected by a client. Echoing both connection IDs gives clients some assurance that the server received the packet and that the Version Negotiation packet was not generated by an attacker that is unable to observe packets.¶

An endpoint that receives a Version Negotiation packet might change the version that it decides to use for subsequent packets. The conditions under which an endpoint changes its QUIC version will depend on the version of QUIC that it chooses.¶

See [QUIC-TRANSPORT] for a more thorough description of how an endpoint that supports QUIC version 1 generates and consumes a Version Negotiation packet.¶

7. Security and Privacy Considerations

It is possible that middleboxes could observe traits of a specific version of QUIC and assume that when other versions of QUIC exhibit similar traits the same underlying semantic is being expressed. There are potentially many such traits; see Appendix A. Some effort has been made to either eliminate or obscure some observable traits in QUIC version 1, but many of these remain. Other QUIC versions might make different design decisions and so exhibit different traits.¶

The QUIC version number does not appear in all QUIC packets, which means that reliably extracting information from a flow based on version-specific traits requires that middleboxes retain state for every connection ID they see.¶

The Version Negotiation packet described in this document is not integrity protected; it only has modest protection against insertion by attackers. An endpoint MUST authenticate the semantic content of a Version Negotiation packet if it attempts a different QUIC version as a result.¶

Appendix A. Incorrect Assumptions

There are several traits of QUIC version 1 [QUIC-TRANSPORT] that are not protected from observation but are nonetheless considered to be changeable when a new version is deployed.¶

This section lists a sampling of incorrect assumptions that might be made about QUIC based on knowledge of QUIC version 1. Some of these statements are not even true for QUIC version 1. This is not an exhaustive list; it is intended to be illustrative only.¶

Any and all of the following statements can be false for a given QUIC version:¶

• QUIC uses TLS [QUIC-TLS], and some TLS messages are visible on the wire.¶
• QUIC long headers are only exchanged during connection establishment.¶
• Every flow on a given 5-tuple will include a connection establishment phase.¶
• The first packets exchanged on a flow use the long header.¶
• The last packet before a long period of quiescence might be assumed to contain only an acknowledgment.¶
• QUIC uses an Authenticated Encryption with Associated Data (AEAD) function (AEAD_AES_128_GCM; see [RFC5116]) to protect the packets it exchanges during connection establishment.¶
• QUIC packet numbers are encrypted and appear as the first encrypted bytes.¶
• QUIC packet numbers increase by one for every packet sent.¶
• QUIC has a minimum size for the first handshake packet sent by a client.¶
• QUIC stipulates that a client speak first.¶
• QUIC packets always have the second bit of the first byte (0x40) set.¶
• A QUIC Version Negotiation packet is only sent by a server.¶
• A QUIC connection ID changes infrequently.¶
• QUIC endpoints change the version they speak if they are sent a Version Negotiation packet.¶
• The Version field in a QUIC long header is the same in both directions.¶
• A QUIC packet with a particular value in the Version field means that the corresponding version of QUIC is in use.¶
• Only one connection at a time is established between any pair of QUIC endpoints.¶

Author's Address